M6284F1078-F Honeywell

HONEYWELL FLAME CONTROL
Modutrol IV Actuator 24V Non-Spring Return Foot Mounted with 150 lb-in. torque, Floating (3 steps).
Stock 2 units
Delivery:
24-48h
617.00
617.00 Taxes not included
Calculate the shipping costs
Select country and zip code to calculate the shipping costs
Series 62 Modutrol IV Actuators are spring return and non-spring return motors (per motor type) used to control dampers and valves. The motors accept a floating (TSC) signal from an electronic controller to position a damper or valve at any point between open and closed.
Reference Honeywell M6284F1078-F/U

- Description: Modutrol IV™ Electric Motor
- Internal Auxiliary Switch: 2
- Fail Safe Mode: Non-Spring Return
- Control Signal: Floating (Three-Step-Control)
- Feedback: Linear 10 K.
- Motor shaft: Dual-ended shaft.
- Stroke: Adjustable; 90 to 160 degrees, Symmetrical.
- Torque Rating: 17 Nm 150 lb-in.
- External Auxiliary Switches Available: Yes.
- Voltage 24 Vac, 50/60 Hz, 15 VA.
- Electrical Connections: Screw terminals.
- Shaft Shape/Dimensions: square / 10 mm.
- Mounting: Foot-mounted.
- Weight: 3.5 kg.
- Dimensions: 164 mm high x 140 mm wide x 185 mm deep.
- Temperature Range, Ambient: -40 to +60 ºC.
- Nominal Timing: 30-60 sec.
- Shaft Rotation (upon control signal increase): Clockwise (as viewed from power end) (normally closed)
Approvals: CE EN55011 (Emission) EN50082-2 (Immunity) 73/23/EEC (LVD)
Comments: Adjustable zero and span for split range applications

• Integral spring return returns motor to normal position in the event of power failure on spring return models.
• Integral junction box provides NEMA 3 weather protection if motor is mounted in the upright position.
• Adapter bracket for matching shaft height of older motors is available.
• Spring return motors can operate valve linkages from power end or auxiliary end shafts for normally closed or normally open valve applications.
• All models have dual shafts (slotted and tapped on both ends).
• All models have auxiliary switch cams.
• Fixed torque throughout the entire voltage range.
• Motors are designed for either normally open or normally closed valves and dampers.
• Die-cast aluminum housing.